Injen 07-18 Jeep Wrangler (JK) V6 3.6L/3.8L SES Muffler Delete Kit
$238.48
The Jeep Wrangler is an amazing vehicle that comes from the factory ready to tackle the world. That said, there are a few design flaws that limit the amazing ability the Wrangler has to offer. One of those flaws is the reduced approach and departure angle from the oversize stock muffler and low hanging exhaust tip. Injen has recognized this issue and has an affordable solution that allow you not only improve your approach and departure angles, but also improve performance and completely change the sound of your JK!
SES5003MD is Injen newest muffler delete kit for the 2007-2018 Jeep Wrangler JK (3.6L & 3.8L) and is a fantastic solution for those that want to climb those steeper obstacles without breaking the bank on a high tuck exhaust. In fact, you can easily swap over to this muffler delete for the weekend wheeling trips and then reinstall your OE muffler for your weekly commute, all within 20 minutes.
This isn't a cheap delete kit made from thin cold-rolled steel that will either rust or crack, the Injen Muffler Delete kit is made for 304 stainless steel that is mandrel bent right here in Pomona, CA for durable, long-lasting performance. During the design process, Injen engineers made sure that the install was a simple as possible and retained the use of the factory hanger location. This allows for quick swaps without throwing any wrenches!
As always, the SES5003MD muffler delete works seamlessly with Injen full line of Jeep performance products. From Rotomolded air intakes to throttle respone controllers to complete performance exhaust systems, Injen Technology is here to help you take on the world in your Jeep!
Features
- Direct fit for
- 2007-2011 Jeep Wrangler (JK) V6-3.8L
- 2012-2018 Jeep Wrangler (JK) V6-3.6L
- Provides increased approach and departure angles
- Injen's Muffler Delete Kit replaces the restrictive factory muffler and exhaust pipe.
- Aggressive engine tone, especially under full throttle
- Smooth pipe routing eliminates restriction and greatly improves airflow
- Uses Factory Hanger
- No additional tuning required
- Made from mandrel bent 60MM 304 Stainless Steel
- Simple Bolt-on Installation using factory mounting points with no cutting or welding
- Injen Intake also available - EVO5007 (3.8L) and EVO5008 (3.6L)
- Injen Snorkel also available - EVO15070
- Injen X-Pedal Throttle Respone Controller - PT0013
- Made in Pomona California, USA
- Injen Technology Limited Lifetime Warranty